Colin, I'm afraid that wasn't the fix. Last night I attempted another time series run and again was stopped by the OS_ERROR. I rechecked all the...
I applied Colin's suggestions "Check Windows Power Management - USB Selective Suspend should be OFF. Check Windows Device Manager - Power...
Christopher, I've got the same problem using SGP. Were you able to solve it? Thank you, Jim Seargeant
Bill, I have not attempted a firmware update for some time - certainly not in the last week. Colin, I disconnected and reconnected all of the...
SBIG STXL 6303, SN X17010004 My STXL has been working fine but no more. I’ve been doing long time-series runs. Two nights ago it ran for about...
Thank you, Doug. Will do.
Colin, I did try additional computers with updated drivers, no hubs, short cables, no extensions.
And when I connect USB, the computer device manager under USB controllers sprouts a line that says "Unknown USB Device (Device Descriptor Request...
The power LED shows green. The status LED is steady red. The fan runs. I tried Ethernet again with Maxim DL. The STXL shows up on a network...
SN is X17010004 Couldn't get it to respond via Ethernet, either. Jim Sgt
My STXL 6303 has been working, but now the USB interface died. I get "USB device not recognized" upon connection. I've tried several different...
And I can test with quick turnaround. Jim Sgt
Thank you, Colin. That worked. Jim Sgt
I just started my STL-6303, SN 110394341, connected it via Maxim DL V 6.13, disconnected, shut down Maxim, opened the Driver Checker V4.02, Build...
Eric, I saw the same behavior. CCDOps produced good bias and darks until I ran Maxim. Then bad bias and darks under both Maxim and CCDOps. Turn...
Richard, my troubles with bias and darks were fixed by new drivers and, perhaps, a Maxim DL update. (Can't remember ifthe Maxim update was part...
Mike, yes - sounds exactly the same as the problem I reported, once in the STXL forum and once in the Maxim DL forum. Jim Sgt
Well, the Corning fiber optic cable that I recommended may not be the universal answer. It worked fine with my STXL but when I tried ti use it...
Light frames appear to be normal. A .4 sec dark is all saturated in 1x1, streaks in 2x2. A .4 sec light is normal pattern in 1x1 and 2x2. Same...
It's been a while. Help?! Camera SN is X13010170 Jim Seargeant
Separate names with a comma.
